• Concrete Required:900 lbs (dry wieght) equal to 7.1 cu ft of concrete.

• Dig a hole 2 ft in diameter and 2 ft deep.
• Check your pole and height adjustment. You will want to set at least 15 in of the pole into the concrete base. Mark the pole 15 in from the bottom.
• Mix approximately 820 lbs (dry wieght) of concrete according to the manufacturers directions. Use the concrete mix to fill the hole completely to the top. Tamp it down to release any air pockets.
• Insert the bottom of the pole so the mark is just above the level of the concrete.
• Build up the concrete around the pole so it tapers away from the pole.
• Fill the pole with concrete.
• Use a carpenters level to make sure the pole is plumb, straight up and down in all directions.
• If your pole has a separate bottom section, wait 72 hours before attaching the rest of the pole to the bottom section.
• Mix the remaining concrete to fill the rest of the pole. (after installing the sections).